Rinseless Wash OCDetailing

Directions:
1- Fill one bucket with grit guard half way with water.
2- Create about 1-2 gallons of Rinseless solution mixture in the other bucket with grit guard.
3- Select your cuff less wash mitt and dip in the solution fully submerging.
4- Using Zero pressure slide it across one panel (If paint is quite clean and the panels are small you might do two before rinsing).
5- The dirtier the paint is the faster you take it to the “Rinse bucket” and thoroughly clean BEFORE placing back into your “wash bucket” to absorb more solution.
6- Select your drying towel or another clean towel which you will use for drying ONLY the panel which you have already cleaned.
7- Repeat steps 3-6 across the entire car, drying panels before water is allowed to dry on them.

Dilutions:
-500ml makes up to 2 Gallons of (1:15) Waterless Spray
-500ml makes up to 3 1/4 Gallons of Quick Detailer (1:25)
-500ml makes up to 5 1/4 Gallons of Clay Lubricant (1:40)
-500ml makes up to 26 1/2 Gallons of Rinse-less Wash (1:200)

Notes:
1- During the rinseless wash process it is important to clean entire panels before you move to drying that panel. This is to avoid using a dry towel on an area that is still dirty.
2- Directions for care of Microfiber towels will be found on the bottom of the page which is linked again here – Microfiber Madness

Precautions:
1- Avoid sprinkler and hard tap water being left on the surface to dry
2- Remove bird bombs from vehicle surfaces as soon as possible with Ech2o mix
3- For Gloss or slickness topper -CarPro Reload 500ml (17oz)